Mallobrezzy - An adaptation of a DaveFred design

I wanted to do quick build with drivers I had on hand that utilized a waveguide. The speakers were destined to either be a in secondary listening location or gifted to friends, so a passive design was needed. Having plenty of RS225-8 on hand (remember the PE sale?), I went in search of a waveguided two-way. I ran across @DaveFred 's beautiful Vellabrezzy build, but it didn’t meet the criteria as I don’t own any Scan-Speak tweeters let alone the unobtanium Monacor waveguide. After reading his build thread closer, I realized I did have the needed tweeter…Scan-Speak XT25BG60 :wink:. Now to solve the waveguide issue. The WG-300 is 37.5mm deep and looking into the Augerpro waveguides, I found the R2904 8" waveguide is 38.1mm deep. Close enough to not require a crossover change?..let’s hope not. Will the different WG profiles create a response issue?..that I can detect? :person_shrugging: I printed the guides and trudged on. I CNC’d the baffle from a 1-1/8" stair tread and I sliced up some menards valve shelves. I made sure to maintain the same driver center to center as well as a similar cabinet volume and tuning.

I used the Optimal Port Designer which I’ve used it a few times now (it’s awesome) and picked up the needed crossover parts from @Hifiside. After a bit of gluing, flush trimming, and painting using leftover exterior house paint with some silica sand added, the speakers were complete.

I present the much less visually appealing Mallobrezzy.

8 Likes

That’s fantastic​:+1:t3:

Great job! For others looking at designs that use the NLA Monacor waveguide: Heissmann Acoustics has a waveguide that I believe is a direct Monacor replacement: LINK. It’s not cheap (33 Euros each) and I’m not sure how much shipping would cost. But it does come with a tweeter adapter. Here’s the list of supported tweeters:

Peerless Tymphany: XT25TG30-04, XT25BG60-04, DX25TG09-04, DX25BG60-04

Scan Speak Discovery: D2604/833000, D2604/830000, R2604/832000, R2604/833000

Vifa: XT-300, XD-270

1 Like

Did you use my exact XO?

And what do you think?

Take care,

David.

1 Like

Hi David,

Yes, I tried to get component valves as close as I could. I did a quick FR measurement on the first one I completed which showed a smooth response. In the few hours of listening done in a less than ideal room…they sound great!

2 Likes

I quite like the somewhat industrial, stout look of those! I built something similar, just a smaller version. With the RS180P-4, DX25 in a Visaton waveguide. Also in black; it could be your speakers little sibling!

3 Likes

This can really be an inexpensive build if you have/can get a deal on the RS225-8:

2 x XT25BG60: $70

Crossover parts: $40

3D printed waveguides and ports: $15

8 x value shelves: $25

= $150 + BYOW RS225-8

2 Likes